(Un)limited Design Contest

Short Description:

ALL YOU NEED:

-          3mm plexiglass – 1m x 1m.

-          01 socked with electric wire.

-          Lamp.

 

 

SOME TIPS:

-          As you can see, we used a crystal plexiglass. If you want to use too, you can put another color lamp, you can change with your mood.

-          But, if you want to use a color plexiglass then you have to use a white light, so you don’t have to guess if the lamp will work well.

-          All the sheets is covered with a thin plastic, at both sides. Remove this plastic only AFTER the laser cutter, unlike you will have some charred parts.

-          You have to do the electric before you start to fit the plexiglass parts.

-          Is better if you fits all discs parts in one side blade, then you fit another 3 side blades on 90º, 180º and 270º. Now you start to see the table lamp and fit the others side blades is much easier.

-          Finish the table lamp with the lowest disc, without this disc your table lamp will collapse.

-          With a sheet of 3mm plexiglass you can make 2 table lamps, but only if you use a sheet with 2m x 1m.

-          The blue print shows  two different rectangles ‘cause our laser cutter support sheets at most 0,9m x 0,6m.

-          All table lamp’s parts fits without a glue.

 

 

By

André Teles                      910125517

Camila Murgolo              910112409

Emerson Lucio               910111357

Iago                                   910100842

José Alberto                     910121120

Marcelo Vaz                      310103884

Wesley Stephano            910114668

 

UNINOVE

Industrial Design

4º semestre noturno